Recalling Stored Data - ProMed FTN Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 60
P470110_FTN_promed_West_NEUSS.qxd:Fieberthermometer
3.3 Measuring the temperature of an object
1. Move the selector switch to the bottom position to select object temperature mea-
surement mode
2. Press the ON/OFF button. The LC display is activated. The thermometer performs a
self-test, where all the display symbols are shown in succession.
3. Finally, the last registered reading is displayed along with the M symbol (M = memory)
for 2 seconds.
4. When you hear a short beep and the the symbol for the measuring unit °C flashes,
the thermometer is ready to take the measurement.
5. To begin the measurement, point the sensor at the middle of the object at a distance
of no more than 5 cm. If it has water, dust or dirt on it, remove this first so that the
reading is as accurate as possible.
6. Press the START button. The blue light switches on and the temperature is mea-
sured. The measurement is accompanied by a series of beeps.
7. Release the START button after a few seconds. A long beep indicates the end of the
measurement. Remove the sensor from the measuring position. The display shows
the measured temperature.

3.4 Recalling stored data

The promed FTN infrared thermometer can store up to 30 results.
1.
You can call up your stored data with a short press of the START button, without
having previously switched on the thermometer with the ON/OFF button. The symbol
M will flash on the display next to "- - -".
2.
After a further short press of the START button, memory slot number 1 will appear in
the unlit display, followed directly by the last stored temperature reading. The symbol
M will flash below the unit of measurement.
3.
With a further press of the START button, you can call up the result stored in memory
slot "2". A total of 30 memory slots are available, and these will be displayed in order
if you continue to press the START button.
If a memory slot is empty, the symbol "- - -" will appear next to it in the display.
.
31.08.2010
13:51 Uhr
3 Operation
Seite 27
GB
27

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

470110

Tabla de contenido