Lutron QS Guía De Instalación Y Funcionamiento página 11

Adjusting Window Treatment Settings
Setting Limits (continued)
5. Adjust the currently selected EDU to the desired level for the
close limit (the maximum the window treatment is allowed to
close) using the raise and lower buttons.
6. Press and hold the bottom button on the shade button group
for 5 seconds to store the current position as the close limit.
The LED next to the bottom button will flash quickly for
2 seconds.
7. Repeat steps 2 through 6 to set the open and close limits for
each window treatment assigned to the shade button group.
8. Press and hold simultaneously the top and raise buttons on
the shade button group to exit Limit Setup mode.
Preset Adjustment: Simple Method
1. Use the raise and lower buttons on the shade
button group to set all electronic drive units
(EDUs) of the window treatments to the desired
preset levels.
2. Press and hold the middle button on the
shade button group for 5 seconds to
save the EDU preset positions. The LED
next to the button will flash and then light
continuously, indicating the preset has been
stored.
Note: Once EDU presets have been
assigned to buttons on a shade
button group, those presets are
accessible for an EDU only using the shade button
group it is assigned to, and a shade button group can
access preset levels only for those EDUs assigned to it.
®
(continued)
Preset Adjustment: Advanced Method
• The advanced method for adjusting presets is needed only if
you wish to have the window treatments assigned to the shade
button group set at different positions in the preset. If, however,
you wish all the window treatments in the group to be lined
up with one another in the preset, you should use the Simple
Method at left.
• Entering Assignment mode will cause the window treatments to
move between their open and close limits. Verify that the open
and close limits have been set correctly.
1. On the shade button group whose preset you
wish to adjust, press and hold simultaneously
the top and bottom buttons. The LEDs
next to the buttons will flash. EDUs for the
assigned window treatments will move to
1 2 3 4 5
their closed limits, and EDUs for unassigned
window treatments will move to their open
limits.
2. Press and release the middle button on that
shade button group. The adjacent LED will blink rapidly. EDUs
for assigned window treatments will automatically move to their
current preset settings.
3. Use the raise and lower buttons to move all EDUs
for assigned window treatments together to the
desired preset setting.
4. To move an EDU individually to its desired preset setting, select
the EDU using the top button on the shade button group. Each
time you press and release the top button, a different EDU that
is assigned to that shade button group will open and close in
an 8 in (200 mm) range. Press repeatedly until the EDU for the
window treatment you wish to adjust moves. Adjust that EDU to
the desired height using the raise and lower buttons.
Repeat this step for all assigned EDUs.
5. Once you are satisfied that all the assigned EDUs are set to the
positions you want to assign as the preset, press and hold the
middle button on the shade button group for 5 seconds. The
preset will be saved.
6. Press and hold simultaneously the top and bottom buttons on
the shade button group for 5 seconds to exit to normal mode.
The LEDs next to the buttons will stop flashing.
6
QS Timeclock Installation and Operation Guide 11
1 2 3
OK