Tool Specifications; Machine Elements; Intended Use; Noise/Vibration Information - Bosch GWS 20-180 H Instrucciones De Servicio

Tool Specifications

Angle Grinder
Part number
With residual current-limit control
Part number
Rated power
Output power
No-load speed
Grinding disk dia. max.
Grinder spindle threads
Weight (without optional extras) approx.
Safety class
Please observe the order numbers of the machine. The trade names of the individual machines may vary.
Inrush currents cause short-time voltage drops. Under unfavourable power supply conditions, other equipment may be
affected. If the system impedance of the power supply is lower than 0.25 Ohm, disturbances are unlikely to occur.

Machine Elements

1 Thread for auxiliary handle (3x)
2 Spindle lock
3 On/Off switch
4 Auxiliary handle
5 Grinder spindle
6 Protective guard
7 Clamping screw
8 Coded projection
9 Mounting flange with O-ring
10 Roughing/cutting disc*
11 Clamping nut
12 quick clamping nut*
13 Adjustment screw
* Optional accessories
* Not all of the accessories illustrated or described are included as standard delivery.

Intended Use

The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting stone, a cutting guide is re-
quired.
14 • 1 609 929 C69 • TMS • 21.08.01
GWS 20-180 H
0 601 849 0..
GWS 20-180 JH
0 601 849 9..
[W] 2 000
[W] 1 250
[rpm] 8 500
[mm] 180
M 14
[kg] 4.2
/ II
14 Clamping lever
15 Guard, grinding cup*
16 Grinding cup*
17 Hand protector*
18 Spacers*
19 Rubber sanding plate*
20 Sanding disc*
21 Round nut*
22 Cup brush*
23 Cutting guide with protective vacuuming
hood*
24 Diamond cutting disc*
25 Cutting grinder stand*

Noise/Vibration Information

Measured values determined according to
EN 50 144.
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 90 dB (A); sound
power level: 103 dB (A).
Wear ear protection!
The typical weighted acceleration is 5.5 m/s
When using the auxiliary handle with vibration
absorption, the hand/arm vibration of the power
tool used is typically less than 2.5 m/s
English - 1
GWS 20-230 H
0 601 850 0..
GWS 20-230 JH
0 601 850 9..
2 000
1 250
6 500
230
M 14
4.2
/ II
2
.
2
.