Product Features; Inserting The Batteries; Maintenance And Storage - Medisana CR 870 Instrucciones De Manejo

PRODUCT FEATURES

Extra coarse roller:
white edge
Coarse roller:
blue edge
Cleaning brush
Fine roller: grey edge
(where supplied)
INSTRUCTIONS FOR USE:

Inserting the batteries

1. Open the battery compartment on the underside
of the device.
2. Insert batteries observing the polarity signs
(+ and -) inside the battery compartment.
NOTE: The batteries are stacked with one of the
batteries behind the other two.
3. Close the battery compartment.
How to use
1. Ensure that your feet are clean and dry.
2. Use the switch to select a power setting;
For sensitive skin, or softer skin use the LO
setting.
For harder skin use the HI setting.
3. Using light pressure place the surface of roller
onto the heel or sole of your foot and gradually
move the device around to target areas of hard
skin. Do not use on a single area for more than 4
seconds at a time.
4. Check the results throughout. Once you are happy
with the results turn the switch to OFF.
5. Rinse your feet with clean water & dry before
applying your favourite foot cream.
Cautions
Before use, make sure that the roller is in good condition. Any malformation,
distortion or damage may cause skin injury.
DO NOT APPLY EXCESS PRESSURE OR CAUSE THE MOTOR TO STOP ROTATING. FOR
BEST RESULTS, RUN THE UNIT GENTLY OVER THE SKIN. THIS WILL ENSURE SOFT,
SAFE AND SMOOTH REMOVAL OF DEAD SKIN.
3x AAA batteries
Changing the rollers
To remove the roller.
1. Ensure the switch is in the OFF position.
2. With one hand press the release button on the
side of the device.
3. With the other hand lift out the roller. TIP: It's
easier to lift the roller out from the end closest to
the release button.
To insert a new roller.
1. Loosely position one of the roller pins into the recess on the end furthest from
the release button.
2. Push the other end of the roller into place using the groves to guide it into
position.
3. The roller will secure into place with a click.

MAINTENANCE AND STORAGE

• Always turn the device off before cleaning it.
• Only clean the device with the supplied brush or a dry cloth. Do not use
chemical agents including benzene, alcohol etc.
• Remove batteries if equipment is not going to be used for extended periods
of time, and store batteries in a cool dry place away from direct sunlight and
metal objects.
• If motor power seems reduced, replace the batteries.
• If roller surface becomes worn or less abrasive, fit a new roller.
SERVICE
The service centre address is shown on the attached leaflet.
CR 870 - Article No: 88576 / EAN Code: 40 15588 88576 3
5
Release button
Power switch
Main body