Installing The Wheel - Thrustmaster Ferrari Challenge wheel Manual Del Usuario

INSTALLING THE WHEEL

Fixing the wheel in place (11)
1. Place the wheel on the edge of a table or other flat surface.
2. Insert the shorter end of the threaded rod into the opening at the base of the wheel.
3. Slide the V-shaped piece onto the threaded rod, so that the jaws of the V clamp against
the underside of the table.
4. Place the tightening screw onto the threaded rod, and tighten everything together until
the wheel is perfectly stable. Be sure not to over-tighten the screw, as you risk
damaging the mounting system and/or the table.
Connecting the pedal set
Connect the pedal set's RJ45 connector (10) to the wheel's RJ45 port (8).
plugging in the wheel's USB connector (7) or starting a game!
Calibration of the wheel and pedal set
Calibration is carried out automatically.
Always make sure that the wheel is centered, and be sure not to press on the pedals,
when plugging in the wheel's USB connector (7) or when starting a game!
For safety reasons, never use the pedal set with bare feet or while wearing only
THRUSTMASTER
RESULTING FROM USE OF THE PEDAL SET WITHOUT SHOES.
Always connect the pedal set to the wheel before
socks on your feet.
DISCLAIMS ALL RESPONSIBILITY IN THE EVENT OF INJURY
®
2/10