Cleaning And Storing The Cleaner; Replacing The Brushes - Polaris 9300 Sport Manual Del Usuario

5.2 Cleaning and Storing the Cleaner

The cleaner must be cleaned regularly using slightly
soapy clean water, do not use solvents such a trichloro-
ethylene or its equivalent. Rinse the cleaner generously
using clean water. Do not let your cleaner dry in direct
sunlight near the pool. The cleaner must be stored on its
own caddy, so that it dries quickly.
1. Place the rear wheels on the caddy side wedges as
shown in Figure 29.
1
Figure 29. Position Cleaner on Caddy
2. Roll the unit into place onto the caddy. Refer to
Figure 30.
NOTE The cleaner cable must be disconnected from
the control box before removing the cleaner
from the pool. Wrap the cleaner cable around
the hooks located at the rear of the caddy.
Figure 30. Roll Cleaner onto Place on the Caddy
2

5.3 Replacing the Brushes

The cleaner is fi tted with PVC brushes. There are ''wear''
indicators on the brushes. To maintain cleaner perfor-
mance at its best you need to replace the brushes as soon
as one of the wear indicators has been reached (even if
the blade wear is not even). Zodiac Pool Systems, Inc.
recommends that you replace the brushes every two (2)
years.
1. Lift the cleaner to a vertical position so that the
handle is up. Refer to Figure 31.
1
Figure 31. Clean in Upright Position
2. Separate the edges of the brush and undo the tabs
as shown is Figure 32. Remove the worn brushes.
2
Figure 32. Undo the Tabs of the Brush
3. To install a new brush, position the new brush on
the roller with the spikes facing downwards. Refer
to Figure 33.
3
Figure 33. Install the New Brush
Page 13