Using Preset Stations; Listening To Music Via Blue- Tooth Streaming - Festool SYSROCK BR 10 Manual De Instrucciones

The frequency will change in steps of
0.1 MHz.
5.7

Using preset stations

You may store your preferred FM ra-
dio stations to the preset stations.
There are four memory presets in
your radio.

Press and hold (~1 sec.) the Preset
button [b], [c], [f] or [g] until the
display show <SET MEMO>.
The station will be accessible via the
chosen preset button. The preset
number P1 to P4 will be shown in the
display.
Repeat this procedure as required for
the remaining presets. Stations
stored in preset memories may be
overwritten by retracing the steps
above.
Recalling preset stations

Press the required Preset button
[b], [c], [f] or [g] to tune to the sta-
tion stored in preset memory.
5.8 Clock time - Radio Data Sys-
tem
Your radio will synchronize and dis-
play clock time [d] whenever it tunes
to a radio station using RDS with CT
signals. If the station has sufficient
signal strength the clock will auto-
matically synchronize within one or
10
two minutes. The radio clock time
will be valid for 24 hours each time
the radio time is synchronized with
RDS CT.

If no RDS-signal is received, the
clock time is not shown.
5.9 Listening to music via Blue-
tooth streaming
You need to pair your Bluetooth de-
vice with your SysRock before you can
auto-link to play/stream Bluetooth
music through your SysRock. Pairing
creates a "bond" so two devices will
recognize each other and establish a
link that enables data transfer.
Pairing your Bluetooth device for the
first time

Press the Source button [j] to se-
lect the Bluetooth mode.
The Bluetooth status icon
flashes to show the SysRock
is discoverable.

Activate Bluetooth on your mobile
device according to the device's
user manual to link up to the Sys-
Rock.

Locate the Bluetooth device list
and select <SysRock>. Some mo-
bile devices (which are equipped
with bluetooth interfaces older
than the BT2.1 standard.), require
entering the pass code "0000".