Philips WP3892/01 Manual Del Usuario página 14

7 Cleaning and
maintenance
7.0.1 Cleaning the pure water dispenser
Warning:
B
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as petrol or
acetone to clean the appliance.
Warning:
B
Do not pour water over the pure water
dispenser.
Clean the outside of the pure water
1
dispenser regularly with a damp (not wet)
cloth.
If you have not used the appliance for 2 days
2
or more, perform the PureFlush procedure
(see chapter 'Using the appliance', section
'PureFlush').
7.0.2 Cleaning the macro filter
Switch off the pure water dispenser.
1
Turn off the water supply to the pure water
2
dispenser.
Unscrew the water inlet connector (hold it
3
in vertical position to avoid water spillage)
and pull out the macro filter.
Rinse the macro filter under a running tap.
4
Remove the dirt from the mesh.
Put the macro filter back in its original
5
position.
Reattach the water inlet connector.
6
1
7.0.3 Cleaning the quartz tube
We advise you to clean the quartz tube once
every  months.
Warning:
B
Handle the quartz tube with care, as it might
break and cause injury. Do not tamper with the
quartz tube (apply glue, etc.).
Switch off the pure water dispenser.
1
Open the cover of the UV chamber.
2
To remove the UV lamp unit, follow steps 1
3
to 5 in section 'Replacing the UV lamp unit'.
Pull out the quartz tube with the rubber
4
ring.
Remove the rubber ring.
5
Clean the quartz tube with a clean moist
6
cloth and dry it completely.
Reinsert the rubber ring to a depth of 2-
7
3mm from the open end.