Preparing For Use - Philips WP3892/01 Manual Del Usuario

Quality Association, USA) for products
that meet or exceed industry standards for
contaminant reduction, structural integrity
and material safety.
4 Preparing for use
We advise you to have the pure water dispenser
installed by trained service technicians.
Note:
D
If the water pressure in your area is lower than
the specified minimum pressure (0.5 bar), we
advise you to use a suitable domestic water
pump.
Note:
D
If the water pressure in your area is higher than
the specified maximum pressure (2.0 bar), the
use of a pressure reducing valve is required.
4.1 Installation
Select a suitable location for the pure water
1
dispenser.
• Install the pure water dispenser at a
convenient and safe location where it
poses no risk of injury.
• Install the pure water dispenser 1m away
from the tap.
1m 1m
• Install the pure water dispenser
in vertical position. Do not install it at an
angle or in horizontal position.
• Only connect the mains plug of the pure
water dispenser to a socket located
higher than the pure water dispenser.
• Make sure that the display is at eye level
or slightly above eye level.
Drill 3 holes in the wall as shown in picture.
2