Charging The Battery Pack - Oregon BL300 Manual De Instrucciones

OPERATING THE BLOWER

CHARGING THE BATTERY PACK

WARNING: FAILURE TO FOLLOW
PROPER CHARGING PROCEDURES
MAY CAUSE EXCESSIVE VOLTAGE,
EXCESSIVE CURRENT FLOW, LOSS
OF CONTROL DURING CHARGING,
LEAKAGE OF HAZARDOUS
CHEMICALS, HEAT GENERATION,
BURSTING OR FIRE. FOLLOW THESE
CHARGING INSTRUCTIONS.
With the charger cord connected to the
charger and plugged into an electrical
outlet, align the grooves in the battery
with the rails on the charger and slide the
battery pack onto the charger until fully
seated (Fig . 8) .
FIG. 8
Check the charge-state indicator for
charging conditions .
18
OREGON® Cordless Tool System
BLOWER MODEL BL300
INSERTING AND RELEASING
THE BATTERY PACK
Only use the OREGON® brand battery
packs specified in these operating
instructions .
Align the groove in the battery with the
rails inside the battery port . Firmly insert
the battery pack into the blower's battery
port, pressing forward until it clicks as it
locks into place (Fig . 9) .
FIG. 9
To remove the battery pack, lift up on
the battery release, grasp the sides of the
battery pack and remove it (Fig . 10) .
FIG. 10
AA 1214 - F/N 571703