5 After use
23
24
25
36
Proceed as follows to clean the rear brush
roller:
1. If you have not done so already:
- Switch off the appliance
'Switching off'.
- Remove the battery pack
'Inserting the battery pack'.
- Put down the appliance so that the bot-
tom of the brush roller is pointing up and
the brush rollers are visible.
2. Unlock the V-belt cover (Fig. 23) and take
it off.
3. Take the back brush roller out of its holder
(Fig. 24).
4. Remove any adhering hair, fluff and the
like by hand or carefully with scissors.
ATTENTION:
If you have to use scissors, ensure that you
do not cut off any bristles or damage the
brush roller in any other way.
5. Guide the rear brush roller back into its
holder.
6. Observe the following when doing so:
- Align the brush roller at an angle so that
it is first correctly put onto the drive
shaft.
- Then lower the brush roller so that the
plate of the brush roller engages per-
fectly with the holder (Fig. 24).
NOTE:
Otherwise the rear brush roller will not be
driven at all or not be driven correctly, thus
rendering it ineffective.
7. Put on the V-belt cover and push down
both locks forcefully until you can feel and
hear them click into place.
Chapter 5.1,
Chapter 3.3,