Setting Up The Charging Station - Dirt Devil Verso Manual De Instrucciones

3 Before use
3.1 Unpacking
3 Before use
1. Unpack the appliance and all its accesso-
ries.
2. Check the contents for completeness and
possible damages (Fig. 1).
NOTE:
Immediately contact your dealer if you have
found damage resulting from transport.

3.2 Setting up the charging station

ATTENTION:
Select a place for the charging station
where the appliance is stable and always
protected from heat and moisture during
charging.
A
2
A
3
18
ATTENTION:
Always transport or ship the appliance in its
original packaging to avoid damage. Keep
the packaging for such an event. Dispose of
no longer needed packaging material
according to the laws of your country of res-
idence.
NOTE:
Upon delivery, the mains adapter's power
cord is already connected to the charging
station.
If the mains adapter's power cord has unex-
pectedly come out of its socket (e.g. by get-
B
ting caught when setting down the appliance)
or if you have purposefully removed the power
cord, you can re-attach it to the charging sta-
tion as follows:
1. Connect the mains adapter to the provid-
ed socket in the charging station (Fig. 2/A,
B).
2. Feed the mains adapter's power cord
through the hole at the base of the charg-
ing station (Fig. 3/A).
B
3. Pull the cable relief of the mains adapter's
power cord through the hole until it cannot
be pulled any further (Fig. 3/B).
NOTE:
The cable relief is intended to prevent the
mains adapter's power cord, that has just
been inserted, from coming out of its socket
if the cable is unintentionally pulled on.