Frost-Free Storage; Warranty And Support; Troubleshooting - Philips SENSEO HD7836/11 Manual De Instrucciones

- The machine is intended for normal
household use only. It is not intended for
use in environments such as staff kitchens
of shops, offices, farms or other work
environments. Nor is it intended to be
used by clients in hotels, motels, bed and
breakfast and other residential environments.
Compliance with standards
-
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.
-
The energy consumption of this machine in off mode is less than
1 watt. This means that this machine complies with European Directive
2005/32/EC, which sets the ecological design requirements for energy-
using products.

Frost-free storage

If you already used the coffee machine and have therefore already flushed
it with water, you may only use and store it in a frost-free place to prevent it
from becoming damaged.
Ordering accessories
To buy accessories or spare parts, visit www.shop.philips.com/service or
go to your Philips dealer. You can also contact the Philips Consumer Care
Centre in your country (see the international warranty leaflet for contact
details).

Warranty and support

If you need information or support, please visit www.philips.com/support
or read the international warranty leaflet.
The purchase of this coffee machine does not exhaust any of the rights
of Jacobs Douwe Egberts or Philips under any of their patents nor does it
confer upon the purchaser a licence under these patents.
Recycling
-
This symbol means that this product shall not be disposed of with
normal household waste (2012/19/EU) (Fig. 1).
- Follow your country's rules for the separate collection of electrical
and electronic products. Correct disposal helps prevent negative
consequences for the environment and human health.

Troubleshooting

This chapter summarises the most common problems you could encounter
with the machine. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Centre in your country.
Problem Solution
The CALC light You have pressed the 1-cup button and the 2-cup
flashes. button at the same time. This started the descaling
cycle. If you did not intend to start the descaling
cycle, simply press the on/off button to switch off
the machine. If you did intend to start the descaling
cycle, do not interrupt this cycle but let the appliance
operate until the water reservoir is empty.
The CALC The descaling procedure has not been completed.
light lights up Perform the descaling procedure as described in
continuously after chapter CALC. Do not switch off the machine during
descaling. descaling.
Water continued The machine was performing the flushing cycle.
to flow from the You have to place a bowl of 1.5 litres under the spout.
spout when I used
the machine for the
first time.
The light ring Make sure that there is enough water in the water
around the on/off reservoir and that the water reservoir is placed
button continues to properly.
flash rapidly.
There is not enough water in the water reservoir
(i.e. above the MIN level if you want to brew 1 cup).
Check if the float in the water reservoir is stuck.
Empty the water reservoir and shake it a few times
to release the float. Clean the water reservoir with
hot water and some washing-up liquid or in the
dishwasher.
I cannot open the A temporary vacuum has developed under the lid.
lid. Switch off the coffee machine. Pull up the lever and
wait 24 hours before you open the lid. You may
need to use some force. Always make sure the pod
holders are clean and the sieve is not clogged to
prevent vacuum.
Problem Solution
The coffee Make sure the intensity switch on the front of the
machine produces machine is in the right setting. When you adjust
less coffee than the switch, the volume in the cup is also adjusted
before. (HD7833, HD7831 only).
Check the pod holder. If the sieve is clogged, use a
washing-up brush to unclog the sieve. If you cannot
clean it properly with the washing-up brush, put the
pod holder in the machine and descale the machine
(see chapter CALC).
Descale the machine (see CALC).
Water leaks from Make sure that you do not overfill the water reservoir.
the machine. Check that you place the water reservoir on the
appliance correctly.
Check the pod holder. If the sieve is clogged, use a
washing-up brush to unclog the sieve. If you cannot
clean it properly with the washing-up brush, put the
pod holder in the machine and descale the machine
(see chapter CALC).
Make sure that the coffee pod has been put properly
in the centre of the pod holder.
In all other cases, contact the Philips Consumer Care
Centre in your country.
I cannot close the Check if a used coffee pod is sticking to the water
lid properly. distribution disc. If this is the case, remove the used
pod.
Check if you used the correct pod holder. Use 2 pods
in combination with the deeper 2-cup pod holder.
The SENSEO® Make sure that the intensity switch is in the position
coffee is not strong you want (HD7833, HD7831 only).
enough.
Make sure that you place the coffee pod(s) properly
in the centre of the pod holder and ensure the coffee
in the pod is evenly distributed.
If you prefer a more robust flavour, SENSEO® coffee
pods with a stronger blend are available.
The SENSEO® Make sure that the intensity switch is in the position
coffee is too strong. you want (HD7833, HD7831 only).
If you prefer a milder flavour, SENSEO® coffee pods
with a milder blend are available.
The coffee is not Do not use cups that are too large, as they cause the
hot enough. coffee to get cold more quickly. Make sure the cups
have a capacity of at least 150ml.
The machine has Contact the Philips Consumer Care Centre in your
been stored in a country.
room that was not
frost-free.
Tips and instructions
Flush the machine before first use and if the machine has not been used
for one day. After the flushing cycle (which only takes approx. 2 minutes),
the machine is ready for brewing SENSEO® coffee.
-
Select the desired coffee strength by turning the intensity switch.
By adapting the strength, you increase or decrease the amount of coffee
in the cup (HD7833, HD7831).
-
While the machine is heating up, you can select the number of cups you
want to brew. The machine brews the cup or cups immediately after it
has heated up.
-
You can stop the brewing cycle at any time by pressing the same button
(1-cup button or 2-cup button) that you pressed to start brewing coffee.
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the machine. All detachable parts ar
dishwasher-proof.
2x descaling, 2x rinsing
Descale the machine when the CALC light goes on. Use Senseo descaler
(HD7012, HD7011) only. The descaling procedure consists of a descaling
cycle and two flushing cycles. Use a used pod in the 1-cup pod holder
during the first descaling cycle and use a new used pod in the 2-cup pod
holder in the second descaling cycle. Do not interrupt the descaling cycle
and do not switch off the machine before you have performed the two
flushing cycles. The CALC light continues flash until the descaling procedure
is completed correctly.For more information on why it is important to
descale, when to descale and how to descale or which descaler to use,
visit our website at www.philips.com/descale-senseo.