General Information - Hayward Swimclear Manual Del Usuario

Your Hayward SwimClear™ cartridge filter combines superior water filtration with ease of operation and totally corrosion-
resistant construction. They are designed for continuous or intermittent operation, for installation above or below the pool
water line, for fresh or salt water swimming pools or spas. SwimClear™ filters utilize multiple reusable, reinforced polyester
filter cartridge elements to provide a high degree of water clarity and long filter cycles with minimum care.
⚠
WARNING
– This product should be installed and serviced only by a qualified pool professional.
C 66 cm
B
A
45,7 cm
Inches
C3030EURO
C4030EURO
C5030EURO
C7030EURO
Page 4 of 8

GENERAL INFORMATION

INSTALLATION
12,7 cm
31,75 cm
A
Cm
34.5 88
40.5 103
46.5 118
52.5 133
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Only simple tools (screwdriver and wrenches), plus pipe sealant
for plastic adapters, are required to install and/or service the filter.
1. The filter system should be installed on a level concrete slab or
other rigid base. Select a well drained and vented area, one that
does not flood when it rains. Position the filter so that the piping
connections, and winter drain are convenient and accessible for
operation, service, maintenance and winterizing.
2. Position filter so the filter will drain by gravity.
3. If practical, place pump and filter in the shade to shield it from
continuous, direct heat from the sun.
4. Connect the pool suction plumbing between the skimmer, pool
outlet and the pump.
5. Install the pool return plumbing.
6. If pressure gauge is not installed, apply Teflon tape to the gauge
threads and carefully screw the gauge into the gauge adapter
assembly.
7. Do not locate pump controls over or near filter.
8. Verify water discharge from the filter manual air relief valve is
directed away from electrical devices
"B" Side
Inches
18
18
18
18
SwimClear™
Required clearance
"C" Side
Cm Inches
46 16
46 18
46 22
46 28
Cm
41
46
56
71
Rev. B