Setup Options; Service And Maintenance - Festool SYSLITE KAL Manual De Instrucciones

GB KAL
Charging state indicator green -
permanently lit
Integral battery is charged to 80%
and then charged fully with a re-
duced current.
Charging state indicator red -
flashing
General fault indication, e.g. incom-
plete contact, short circuit, battery
faulty.
Charging state indicator red -
permanently lit
Battery temperature is outside the
permitted range.
6.2 On/Off switch [1-2]
The on/off switch [1-2] has three
settings:
– Press once -> activate LED with
max. luminosity
100%)
– Press twice -> reduce the lumi-
nosity (stage 2: 30%)
– Press three times -> switch off

6.3 Setup options

Attachment handle [1-3]
The folding attachment handle al-
lows you to hang the working light
from scaffolding or similar struc-
tures.
L
If you decide to operate the
light with an external Festool
battery pack, the attachment
handle must be detached be-
forehand [2A].
14
Setup angle
The working light can be positioned
at three different angles [3].
Tripod
A standard photographic tripod with
UNC 1/4"-20 thread can be attached
to the threaded tripod socket [2-1].
6.4 Temperature monitoring
If the temperature of the light ex-
ceeds the maximum or minimum
permitted operating temperature,
the working light switches to emer-
gency power mode with reduced lu-
minosity and then switches off after
30 seconds.
6.5 Operating with external
The working light can operate with
(stage 1:
any Festool battery pack from the
BPC or BPS series. When connected
to the external Festool battery pack,
the working light only consumes
power from this battery pack.
L
7
– Always clean the plastic cover on
– Keep the contacts on the work-
– Always appoint an authorised
Festool battery pack [2A]
+ [2B]
Only compatible Festool charg-
ers can charge the Festool bat-
tery pack.

Service and maintenance

the working light using a soft,
dry cloth to prevent any dam-
age. Do not use solvents.
ing light and battery pack clean.
service workshop to replace
damaged integral batteries.