Symbols - SIKA PowerCure Serie Manual De Instrucciones

Define additional safety measures to protect
the operator against the effect of vibrations,
such as: maintenance of the PowerCure dis-
penser and tool inserts, keeping hands warm,
organisation of the working procedures.
Vibration value
Uncertainty
2.4

Symbols

Please read the instructions for
use carefully before startup.
Please read the instructions for
use carefully before startup.
Do not charge a damaged battery,
instead renew it immediately.
Do not burn batteries.
Electrical devices are not
allowed to be disposed of as
domestic waste. Electrical and
electronic devices must be
collected separately and taken
to a recycling company for
environmentally friendly disposal.
Contact the local authorities or
your specialist dealer to ask about
recycling and collection points.
Take the waste for recycling.
CE mark
Eurasian customs union mark
After the battery has been
inserted into the slot in the
charger, it will be charged
automatically. The red LED
(Fig. 6 A) lights up steadily.
30
ah = 0.6 m/s
2
K = 1.5 m/s
2
When the battery is fully charged,
the LED on the charger changes
from red (Fig. 6 A) to green
(Fig. 6 B). There is no need to
remove the battery from the
charger once it has been charged.
The battery can be left in the
charger continuously. It will not
be excessively charged, and it
will be ready for use at all times
The red LED flashes (Fig. 6 A)
if an excessively hot or cold
battery is inserted into the
charger. The charging procedure
starts automatically as soon
as the battery has reached the
correct charging temperature
(0 °C ... 65 °C). The max.
charging current flows when the
temperature of the Li-ion battery
is between 0 and 65 °C.
If red (Fig. 6 A) and green
(Fig. 6 B) LEDs flash alternately,
this means either the battery
is not completely pushed on, or
there is a fault in the battery or
the charger. For safety reasons,
immediately take the charger
and battery out of operation and
have them checked at a customer
service point.
Power tool in protection class II.
Power tool in which the protection
against an electric shock does not
depend on the basic insulation,
but also on the use of additional
protection measures such as
double insulation or reinforced
insulation. There is no fixture for
connecting a protective earth
conductor.
The device is only suitable for use
indoors. Do not expose the device
to rain.
Slow-blow equipment fuse 3.15 A
T3.15A