Bluetooth Connecting with Solar Stone
Connecting to One Solar Stone
1.
Power on Solar Stone by holding down the power button. You will hear "Power On" for confirmation. *
2.
Press the Bluetooth Connect button briefly to enter Connecting Mode - the Bluetooth LED will blink
fast, and you will hear "Pairing" to indicate this. *
3.
Navigate to your device's Bluetooth setup screen, find Solar Stone, and connect. Bluetooth LED will
light up solid when it is connected and you will hear "Pairing successful, connected" for confirmation.
*
Note: If you experience trouble in connecting, select "Forget this Device" on your Bluetooth device
and try to connect again.
4.
To disconnect, hold the Bluetooth Connect button on Solar Stone. You will hear "Disconnected" for
confirmation. *
5.
If your Bluetooth device is not able to connect to Solar Stone, hold the Bluetooth Connect button on
the speaker to break previous Bluetooth connections and reset the Bluetooth module.
Linking Two Solar Stones to each other for Stereo Sound
Note: Ensure that the speakers are not already Bluetooth connected in single mode. If either of them is
connected, hold the Bluetooth Connect button to disconnect and then follow the steps below.
1.
Power on each Solar Stone by holding down their power buttons. You will hear "Power On" for
confirmation. *
2.
Press the Link button on each Solar Stone. The speakers will search for each other while playing an
intermittent tone. Once the stereo pair is successfully linked, you will hear "Pairing successful,
connected" followed by "Left channel" and "Right channel" on the respective speakers. *
This process may take up to 2 minutes the first time two speakers are linked. Speakers that were
previously linked will relink automatically in a few seconds if powered on in range of one another.
Note: Solar Stones should be within 30 ft. (9 m) of each other to Link properly.
3.
On the Left speaker, the Bluetooth LED will blink. Press the Bluetooth Connect button briefly to
enter Bluetooth Pairing mode.
Note: The Left speaker will be the "master" speaker, and the unit from which the Bluetooth range will
be determined.
4.
Navigate to your device's Bluetooth setup screen, find Solar Stone, and connect. You will hear
"Connected" for confirmation. *
Note: If you experience trouble in connecting, select "Forget this Device" for Solar Stone on your
Bluetooth device and try to connect again.
5.
To disconnect linking, hold the Link button on the "master" Solar Stone for 2 seconds. You will hear
"Disconnected" for confirmation. *
6.
If your Bluetooth device is not able to connect to Solar Stone, hold the Bluetooth Connect button on
the speaker to break previous Bluetooth connections and reset the Bluetooth module.
Note: When two speakers are linked, hold the power button on the "master" speaker to turn both
speakers off. If you want to only turn off the "slave" speaker, press and hold the power button on that
speaker. The speakers will relink automatically the next time they are both powered on.
* Tip: If you would like to disable (or enable) the voice prompts, simultaneously press the Bluetooth
Connect and Link buttons briefly.
5