Küchenprofi VISTA2 Manual De Instrucciones página 11

Before using for the first time
· Please first read these operating instructions and the safety instructions
carefully.
· Remove all packing material first and dispose of it properly.
· Wipe the housing with a moist cloth and dry thoroughly.
· Please clean the cold stone with warm water and a sponge. Do not use
dishwashing detergent.
· You can clean the pans and the spatulas with hot water and some mild
dishwashing detergent. Please thoroughly dry all parts.
· Prepare the stone as described in „Care instructions for the stone", then
place it on top of the raclette device with the juice groove facing
upwards. Ensure that it lies safely in the support.
· Heat the empty device for approx. 10 minutes; the slight smoke and
odor that will probably be produced is completely harmless. This is only
protective oil, which was applied during production. Ensure good
ventilation of the room during this period!
Care instructions for the stone:
· Due to natural conditions, there may be variations in the color and -
structure of the stone. This is not a defect nor does it adversely affect
function. On the contrary, this emphasizes the fact that the stone is a
natural product and that therefore no two stones are the same.
· To ensure that your new product brings many years of enjoyment,
please follow these care instructions thoroughly.
· Because this stone is a natural product, it can have internal stresses.
These could lead to cracks or even breakage of the stone if the
temperature is changed too quickly. This can be largely avoided by
observing the following the one-time procedure. This will increase the
stability of the stone and "relieve" the internal stresses. Nonetheless,
small cracks can appear in the stone during later use, which do not
have an adverse effect on the function. Stones with small cracks are
therefore excluded from the warranty and from replacement. The color
of your stone will change during this process and in later use.
1. First, clean the stone under running warm water.
2. Thoroughly dry the stone with a cloth.
3. Now, place the stone on the grate in the cold oven and heat it to
220°C.
4. Switch off the oven after approximately 40 minutes and allow the
stone to cool slowly to room temperature.
5. Caution: Never chill the stone with cold water, to avoid
temperature shock!
Your stone is now ready for further use.
Use
· Use a washable, heat resistant surface because of the possible risk of
spattering.
· Caution: Please ensure that the power cable and pans do not touch
the heating coils!
· Place the stone on the device with the juice groove facing upwards.
Never place the cold slab on the preheated device.
· Insert the plug into the power outlet.
· Switch on the device and allow it to preheat for approx. 8 – 10 minutes,
so that the stone slab reaches operating temperature.
· Cover the stone and the pans when needed with a thin coating of oil,
butter, etc.
D G B
11