Filling The Water Reservoir - Fagor FGBV50 Manual De Instrucciones

• Check that the product is intact and not damaged.
• Clip the Brush (8) to the steam mop Body (15) until the brush release button clicks
(7). [Fig B1]
• Remove the brush (8) by pressing the brush removal button (7) and remove the
brush.
• Insert the handle (1) in the steam mop body (15) until the handle release button
clicks (12).[Fig B2]
• Remove the handle (1) by pressing the handle release button (12) and remove.
• Place the Microfibre Cloth (16L) on the floor with the Velcro side facing up and
place the brush (8) on it and press lightly, making sure to cover the entire surface of
the brush. [Fig. B3]
W
ARNING: SCALDING HAZARD
B
efore removing the cloth (16L), after use, ALWAYS switch off the steam cleaner and
wait a few minutes until the brush (8) has cooled.

FILLING THE WATER RESERVOIR

• Turn the water reservoir (13) anti-clockwise until the arrow reaches the "open"
symbol and remove it. [Fig. C1]
• Remove the top rubber cap and fill the reservoir with water up to the MAX level.
[Fig. C2]
• Close the rubber cap and reposition the water reservoir (13) in the relevant seat