Noise / Vibration Information; Switching On/Off - Festool RENOFIX RG 130 E Manual De Instrucciones Original

5.3

Noise / Vibration Information

Measured values determined according to EN 60 745.
Typically the A-weighted noise level of the tool are:
Sound pressure level:
Sound power level:
Inaccuracy of measurement
CAUTION
Operating noise
Damage to hearing
 Use ear protection!
Vibration emission value a
directions) and uncertainty K measured in accord-
ance with EN 60 745:
Uncertainty
The specifi ed emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with oth-
er insertion tools or if not maintained adequately.
Take note of idling and downtimes of machine!
6 Activation
WARNING
Risk of accident if the machine is operated us-
ing unauthorised voltages or frequencies.
 The mains voltage and the frequency of the
power source must correspond with the
specifi cations on the machine's name plate.
 In North America, only Festool machines with
the voltage specifi cations 120 V/60 Hz may
be used.
6.1 Switching on – off
Switching on
 Push the locking lever [1-2] forwards to unlock
the on/off switch [1-1].
 Press the on/off switch [1-1] at the same time.
 Continuous operation: simultaneously press-
ing the locking lever [1-2] forwards locks the
on/off switch.
The electric power tool starts.
14
95 dB (A)
106 dB (A)
K = 1.5 dB (A)
(vector sum for three
h
a = 5.2 m/s²
h, AG
K = 1.5 m/s²
Only make contact with the material once the
machine has reached operating speed.
Switching off
 Lift the electric power tool from the processed
material.
 Release the on/off switch [1-1].
 During continuous operation: briefl y press the
on/off switch [1-1].
WARNING
Risk of injury
Rebound, ejected parts
 Before setting down the machine, wait until
the rotating tool has come to a complete stop.
6.2 Regulation electronics
Starting current limitation
Electronically controlled continual running se-
cures device acceleration without back thrust.
Due to starting current limitation in the device,
16 A protection is suffi cient.
Electronic revolutions pre-setting
Use the revolutions regulator [1-4] for smooth
revolutions pre-setting:
Level 1: 3000 min
–1
Level 2: 4000 min
–1
Level 3: 5000 min
–1
Required number of revolutions depends on ap-
plied grinding wheel and worked material.
Switching off during back thrust
During sudden drop of revolutions under extreme
load, the current input in motor stops. For re-
starting, the device must be fi rst switched off and
again switched on.
Protection against re-starting
Prevents the uncontrolled starting of the de-
vice after current supply cut off. For re-starting,
the device must be fi rst switched off and again
switched on.
Constant electronics
Constant electronics maintains the number of
revolutions during idle operation and under load
to the same value; it guarantees a constant work-
ing shift and balanced stock removal.
Heat protection during overloading
The safety electronics switches the motor cooling
regime when the critical temperature is reached
in order to protect it from overheating under per-
manent extreme load. The machine cannot be
loaded, it runs on reduced rpm. After cooling in
Level 4: 5800 min
–1
Level 5: 6700 min
–1
Level 6: 7700 min
–1