Symmons 2DIV-BODY Manual De Funcionamiento Y Mantenimiento página 3

Installation
Important: Do not plug
outlet ports. Do not use
diverter as shut-off valve.
Important: Do not expose
diverter valve to heat for
longer than 2 minutes when
sweating in copper tubing.
Doing so may damage the
internal components of
the valve and will void the
product warranty.
Note: Diverter valve can be installed
in wall with shower valve or in an
adjoining wall to shower valve.
1) Reference rough-in dimension for
shower application with diverter
for proper installation of diverter
valve.
2) Shut-off water supplies.
Operation (for diverter valves purchased after August 17, 2016)
1) Cartridge is factory set to divert
to function 1.
Note: Additional handle positions for same output are illustrated.
3) Position diverter valve (E) so port
marked IN is facing down.
E
!
4) Secure stringer mounts on diverter
valve (E) to wood blocking for
support.
E
Note: Securing stringer mounts is
necessary for applications where
PEX, or other non rigid tubing, is
used to install diverter valve.
2) Turn handle to position 2 to divert
to function 2.
3
5) Sweat 1/2" copper tubing from
inlet port on diverter valve
to water source. Sweat 1/2"
copper tubing from outlet ports
to desired accessories.
Optional: Apply plumber tape to
male IPS threads on the inlet and
outlet ports of diverter valve. Install
1/2"-14 NPT copper fittings to the
inlet and outlet ports. Connect
outlets to desired accessories.
6) Turn on water supplies to flush
plumbing lines free of debris.
Check for leaks.
3) Turn handle to position 3 to share
functions 1 and 2.