Cleaning; Storage; What If There Are Problems - Beurer LE 60 Instrucciones De Uso

7. Cleaning

WARNING
Before cleaning, always ensure that the mains plug of the air dehumidifier has been properly discon-
nected.
Regular cleaning is a prerequisite for hygienic and fault-free operation. Always empty and thoroughly clean
the water tank of the air dehumidifier if the device has not been used for more than 3 days. A lack of cleaning
and hygiene can cause bacteria, algae and fungi to form in the water.
Cleaning the housing
• Clean the air dehumidifier with a damp cloth (water or a mild cleaning solution). When cleaning, do not
use any solvents or other aggressive or abrasive cleaning agents as the surface could become damaged.
Cleaning the water tank
1. Carefully pull the water tank out backwards as shown.
2. Remove the lid of the water tank by pulling it upwards.
3. Rinse out the water tank with clean water every 2 weeks. With very
intensive use, the water tank should be cleaned at even shorter inter-
vals. If necessary, remove any deposits in the water tank using a plastic
brush.
Cleaning the filter
1. First remove the plastic cover with integrated filter on the rear of the air
dehumidifier.
2. Clean the filter with a vacuum cleaner or rinse it under clean water. Then
allow the filter to dry out. Do not replace the filter until it is completely
dry.

8. Storage

If you do not plan to use the device for 2 to 3 days, we recommend that you unplug it and store it thoroughly
empty, clean and dry in the original packing in a dry environment. Ensure that no objects are placed on top
of the device.

9. What if there are problems?

Problem
The device is not working.
Cause
The device is not connected to
mains power supply.
The device has switched itself off
due to safety reasons.
Solution
Connect the mains plug and switch on
the device.
Clean and refill the device before next
use. Then switch it on again.
21