Schluter Systems LIPROTEC-EASY Manual De Instrucciones página 46

LIPROTEC-P Operating Instructions
LED tubes »
1
The silicone-coated LED tubes are available in different lengths, widths and light variants,
each in a set with a mounting profile ( » "Mounting profile » /6" on page 49 ). The power
supply can be established via the fitted connection cable with pre-assembled plug connector.
LED tubes are available in warm white, neutral white (W-LED) and coloured (RGB+W-LED)
versions.
Technical data
Silicone sealing caps»
Silicone sealing caps are used to seal cut-to-length LED tubes to the cut surface once the
LED tubes have been cut to length. Silicone sealing caps must be glued with the special
adhesive included in the delivery.
Special adhesive »
The special adhesive included in the delivery is matched to the material of the LED tubes
and the silicone sealing caps. It is intended for glueing these two components together. If
this special adhesive is used as intended, it seals the adhesive surfaces to prevent moisture
penetration.
Bluetooth receiver and radio remote control »
The Bluetooth receiver can receive radio signals from the radio remote control and establish
a Bluetooth connection with a mobile device.
The Bluetooth receiver is connected to the power supply, cable, distributor or LED tubes via
the connection cables fitted on both sides. Using a Bluetooth receiver, RGB+W LED modules
can be controlled via the corresponding radio remote control or a mobile device. In addition
to switching it on and off, you can switch between the default settings (Favourites) stored in
the Bluetooth receiver.
The Bluetooth receiver is not intended for use with W-LED tubes.
Technical data
Mounting profile »
Mounting profiles are used for mechanical mounting of the LED tubes and are available as a
set with the appropriate LED tubes ( » "LED tubes »
of mounting profile and LED tube forms an LED module.
Mounting profiles can be used as finishing strips for tiled areas. They are available in two dif-
ferent profile geometries and widths and in different lengths. Aluminium and, for applications
with high corrosion resistance requirements, stainless steel (V4A) are available as material
versions.
/2
» "Technical data for the LED tubes" on page 67
/3
1
/4
1
» "Technical data for the Bluetooth receiver" on page 66
/6
1
/5
1
1
/2" on page 49 ). The combination
EN
49