Motor Overload Protection - Kränzle K 1050 P Manual De Instrucciones

Functional details

Motor overload protection

The motor is protected against overloading by means of an overload protection de-
vice included in the motor coil. In the event of overloading or jamming, the excess
temperature cut-out serves to switch off the motor. In case of repeated switching
off the motor by means of the excess temperature cut-out, make sure to eliminate
the cause of the failure.
Replacements and inspection work should only be performed by quali-
fied persons when the machine is disconnected from the power supply,
i.e. with plug pulled out from the electrical socket.
High pressure hose and spray device
The high pressure hose and spray device which are part of the K 1050 P equipment, are
made of high quality material and engineered to conform with the operating condi-
tions of the high pressure cleaner and are duly labeled.
If replacement parts are required, only such parts that are authorized
by the manufacturer may be used. The warranty is automatically void if
spare parts of third-party providers are used! The high pressure hose and
spray device must be connected in a pressure-tight manner (without
leakage).
The high pressure hose may not be driven over, pulled excessively, or
twisted. The hose may under no circumstances be pulled over sharp edges.
Defective high pressure hoses must not be repaired (acc. to DIN 20022) but
have to be replaced by new hoses approved by the manufacturer.
GB
39