Mounting The Outbackcam - Swann Advanced Serie Instrucciones De Uso

Mounting the OutbackCam

Undo the two clips on the side of the OutbackCam and open the case. Before inserting
batteries or an SD card, ensure that the OutbackCam is turned OFF.
To install/change batteries:
• Locate the battery slots, on the rear of the camera unit.
• Remove any old batteries.
• Insert new ones observing the polarity shown in the battery slots.
• Use only fresh batteries. Do NOT mix battery types.
• You may need to re-configure the OutbackCam when you swap batteries.
To insert an SD card:
• If there is an SD card in the slot already, remove it. To release the SD card, push it
into the slot for a moment then release, and it will 'pop' out.
• Face the SD card so that the data connectors are face down, with the 45° cut
corner orientated to the top right hand side.
Inserting Batteries and an SD Card
The included strap can be used to attach the OutbackCam
to any structure which the strap can fit around. Ensure
you have the required components. You'll need the fabric
strap, and the two halves of the clasp (pictured clipped
together, facing "top-side" up).
1. Feed the fabric strap through the two spaces provided
on the rear of the OutbackCam. Un-clip and separate
the two halves of the clasp.
2. Feed one end of the strap though the bottom side of
the second hole of one clasp, as pictured to the left.
3. Loop the end of the strap back through the first slot in
the clasp, as shown to the left.
4. Repeat for the other half of the clasp. To tighten
the strap, simply pull on the loose ends of the strap
protruding from the clasp. If you find that the strap
slips out of one or both ends of the clasp, then this
indicates that the clasp is upside-down.
Attaching the Strap
7