Operating The Outbackcam - Swann Advanced Serie Instrucciones De Uso

Operating the OutbackCam

Duty Time
Selector
DATE
TIME
DELAY
FORMAT
Menu
MODE
STATUS
Mode
Indicator
When the OutbackCam is turned on, the SETUP button will access the menu
system. The UP and DOWN buttons are used for navigation, while the OK button
selects or confirms an option.
For setting the OutbackCam's date. Use the up and down buttons to adjust a
value, and the OK button to set a value and move on to the next.
When selected, the date will be shown in the numerical display four digits at a
time, first the YEAR and then the MONTH and DAY.
For setting the OutbackCam's time. It will display the time in 24-hour format,
allowing you to select first the HOUR and then the MINUTE.
The amount of time that must elapse between recordings before the OutbackCam
will record again. The time is selected first in MINUTES then in SECONDS.
If you want to clear all the data from an SD card and prepare it for use in the
OutbackCam, this is the option you'll want. Before selecting pressing OK, the screen
will show a total count of the number of recordings made by the OutbackCam.
When Format is selected, the numerical display will display "FONO". These are two
options, where FO means "format" and NO means not to format.
8 8 8
DUTY
8888
1P 3P MOVIE
PIR TL
File Type
Indicator
Setting up the OutbackCam
Date
Time
Delay
Format
PIR+TL
Battery
Indicator
Numerical
Display
SD Card
Indicator