Troubleshooting - Dometic COOLFREEZE CF 35 Instrucciones De Uso

Troubleshooting

9 Troubleshooting
Fault
Device does not
function, LED does
not glow.
The device does not
cool (plug is inserted,
"POWER" LED is lit).
The device does not
cool (plug is inserted,
"POWER" LED flashes
orange, display is
switched off).
When operating from
the DC outlet:
The ignition is on
and the device is not
working and the LED
is not lit.
The display shows an
error message (e.g.
"Err1") and the appli-
ance does not cool.
20
Possible cause
There is no voltage
present in the 12/24 V
socket (cigarette lighter)
in your vehicle.
No voltage present in
the AC voltage socket.
The device fuse is
defective.
The integrated mains
adapter is defective.
Defective compressor.
Battery voltage is too
low.
The DC outlet is dirty.
This results in a poor
electrical contact.
The fuse of the DC plug
has blown.
The DC fuse inside the
device has blown.
The vehicle fuse has
blown.
The appliance has
switched off due to an
internal fault.
CF35, CF40, CF50
Suggested remedy
The ignition must be switched on in
most vehicles to apply current to the
cigarette lighter.
Try using another plug socket.
Replace the device fuse, see chapter
"Replacing the device fuse" on page 18.
This can only be repaired by an
authorised repair centre.
This can only be repaired by an
authorised customer services unit.
Test the battery and charge it as needed.
If the plug of your cooler becomes very
warm in the DC outlet, either the DC
outlet must be cleaned or the plug has
not been assembled correctly.
Replace the fuse in the DC plug, see
chapter "Replacing the plug fuse
(12/24 V)" on page 18.
This can only be repaired by an
authorised repair centre.
Replace the vehicle's DC outlet fuse.
Please refer to your vehicle's operating
manual.
This can only be repaired by an
authorised repair centre.
EN