Replacing The Device Fuse; Replacing The Plug Fuse (12/24 V); Replacing The Light Bulb - Dometic COOLFREEZE CF 35 Instrucciones De Uso

Operation
6.9

Replacing the device fuse

D
DANGER! Danger of electrocution!
Disconnect the connection cable before you replace the device fuse.
➤ Pull off the connection cable.
➤ Pry out the fuse insert (fig. 4 2, page 4) with a screwdriver.
➤ Replace the defective fuse with a new one that has the same rating (T4AL 250V).
➤ Press the fuse insert back into the housing.
6.10

Replacing the plug fuse (12/24 V)

➤ Pull the adapter sleeve (fig. 7 4, page 5) off of the plug.
➤ Unscrew the screw (fig. 7 5, page 5) out of the upper half of the housing
(fig. 7 1, page 5).
➤ Carefully raise the upper half of the housing from the lower (fig. 7 6, page 5)
half.
➤ Take out the contact pin (fig. 7 3, page 5).
➤ Replace the defective fuse (fig. 7 2, page 5) with a new one that has the same
rating (8 A, 32 V).
➤ Re-assemble the plug in the reverse order.
I
NOTE – Internal DC fuse
There is an additional DC fuse inside the device (Automotive standard
blade fuse, 10 A). This fuse can only be replaced by an authorised repair
centre.
6.11

Replacing the light bulb

➤ Press the switch pin (fig. 8 2, page 5) downwards so that the transparent part
(fig. 8 1, page 5) of the lamp can be removed at the front.
➤ Replace the light bulb.
I
NOTE
The LEDs in the light bulb must be aligned with the transparent part of
the lamp.
➤ Press the transparent part of the lamp back into the housing.
18
CF35, CF40, CF50
EN