Remove The Blade; Install The Edge Guide; Operation; Start The Machine - GreenWorks JSD401 Manual Del Operador

EN
1. Rotate the blade clamp lock counterclockwise. Hold the
lock in the open position.
2. Insert saw blade between blade clamp and saw bar.
3. Close blade clamp lock.
6.5

REMOVE THE BLADE

1. Rotate the blade clamp lock counterclockwise. Hold the
lock in the open position.
2. Pull the blade out.
6.6

INSTALL THE EDGE GUIDE

1. Loosen the edge guide knobs.
2. Install the edge guide on either side as needed.
3. Adjust the edge guide as needed.
4. Tighten edge guide knobs.
7

OPERATION

Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
WARNING
WARNING
English
7.1

START THE MACHINE

The machine can not work when the lock-off button is on
the center.
1. Push the lock-off button to the left or right side to unlock
the trigger.
2. Pull the trigger to turn the machine ON.
Variable speed
The machine has a variable speed switch that delivers higher
speed with increased trigger pressure and lower speed with
decreased trigger pressure.
7.2

STOP THE MACHINE

1. Release the trigger to turn the machine OFF.
Release the trigger and allow the machine to come to a
complete stop.
7.3

ORBITAL MOTION

Orbital motion provides faster, more effcient cutting.
Choose from four orbital adjustment position for fine to
aggressive cutting.
0
Hard materials such as metals or thin sheet
metals. This setting can be used with knife
blades, grit edge blades, rasp work, and
down cutting blades.
1
Soft materials where cleaner cutting or del-
icate scrolling work is performed.
2
Medium density materials such as harder
woods or particle board.
8
NOTE
WARNING