Attaching The Blade; Removing The Blade - GreenWorks 32042a Manual Del Propietário

Do not attempt to modify this tool or createaccessories
not recommended for use with thistool. Any such
DOWHUDWLRQ RU PRGL¿FDWLRQ LV PLVXVHDQG FRXOG UHVXOW
in a hazardous condition leadingto possible serious
personal injury.
To prevent accidental starting that could causeserious
personal injury, always remove the batterypack from
the tool when assembling parts.

ATTACHING THE BLADE

See Figure 2-3
BLADE
$  LQ EODGH LV WKH PD[LPXP EODGH FDSDFLW\RI WKH
saw. Never use a blade that is too thickto allow outer
EODGH ZDVKHU WR HQJDJH ZLWK WKHÀDWV RQ WKH VSLQGOH
Larger blades will come incontact with the blade guard,
while thicker bladeswill prevent blade screw from
securing blade onspindle. Either of these situations
could result in aserious accident.
Remove the battery pack from the saw.
Remove the hex key from the storage area.
Depress the spindle lock button and remove the
bladescrew and outer blade washer.
NOTE: Turn the blade screw counterclockwise to remove.
English(original instructions)
WARNING
WARNING
INNER BLADE
WASHER
BLADE SCREW
WARNING
SPINDLE LOCK
BUTTON
To prevent damage to the spindle or spindle lock,always
allow motor to come to a complete stopbefore engaging
spindle lock.
Wipe a drop of oil onto the inner blade washer and
outer blade washer where they contact the blade.
If inner blade washer has been removed, replaceit
before placing blade on spindle. Failure to doso could
Fig. 2
cause an accident since blade will nottighten properly.
Fit the saw blade inside the lower blade guard and
onto the spindle.
NOTE: The saw teeth point upward at the front of the saw.
Replace the outer blade washer.
Depress the spindle lock button, then replace the
blade screw. Tighten the blade screw securely.
NOTE: Turn the blade screw clockwise to tighten.
Return hex key to storage area.
NOTE: Never use a blade that is too thick to allow the
RXWHU EODGH ZDVKHU WR HQJDJH ZLWK WKH ÀDWV RQ WKH VSLQGOH

REMOVING THE BLADE

See Figure 2-3
Remove the battery pack from saw.
Remove the hex key from the storage area.
Position the saw as shown, depress the spindle
lockbutton, and remove the blade screw.
NOTE: Turn blade screw counterclockwise to remove.
EN - 9
HEX KEY
TO LOOSEN
TO TIGHTEN
CAUTION
WARNING
Fig. 3