DeWalt DWD010 Manual De Instrucciones página 26

KEYED CHUCK INSTALLATION (FIG. 4)
Screw the chuck on by hand as far as it will go. Insert the shorter
end of a hex key and strike it in the clockwise direction with a soft
hammer.
MAINTENANCE
Your D WALT power tool has been designed to operate over a
E
long period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular
cleaning.
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories. An accidental start-up can cause injury.
Motor Brushes
D WALT uses an advanced brush system which automatically stops
E
the drill when the brushes wear out. This prevents serious damage
to the motor. New brush assemblies are available at authorized
D WALT service centers. Always use identical replacement parts.
E
Lubrication
Self-lubricating bearings are used in the tool and periodic relubrication
is not required. In the unlikely event that service is ever needed, take
your tool to an authorized service location.
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry air
as often as dirt is seen collecting in and around the air vents. Wear
approved eye protection and approved dust mask when performing
this procedure.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the materials used in these parts. Use a cloth dampened only
with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
personnel, always using identical replacement parts.
Accessories
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D WALT, recommended accessories should be used with
E
this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center.
CAUTION: To reduce the risk of injury, the following accessories
should be used only in sizes up to the maximums shown in the table
below.
MAXIMUM RECOMMENDED CAPACITIES
CHUCK CAPACITY
BITS, METAL DRILLING
WOOD, FLAT BORING
Protegendo o Meio Ambiente Coleta
seletiva
Este produto não deve ser descartado com o lixo doméstico
normal.
Se você constatar que seu produto D
não é mais viável ao uso, não elimine em lixo doméstico.
25
DWD010 DWD014
6.5 mm 10 mm
6.5 mm 10 mm
16 mm 25 mm
WALT necessita de troca, ou
E