Installation And Connection; Remedy Of Faults - Pontec PondoStar LED RGB Set 3 Instrucciones De Uso

- EN -

Installation and connection

 B, C
• Install the transformer at a minimum safety distance of 2 m from the water.
• Install the receiver outside of the water.
• Ensure that the spotlights are positioned and secured so that they do not pose a risk to anybody.
• Connect the plug of the spotlight connection cable to the socket on the transformer and hand-tighten the union nut.
• Position the spotlights outside of the water or in the water and tilt the light head as desired.
Commissioning/start-up
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
N O T E
The unit will be destroyed if it is operated with a dimmer. It contains sensitive electrical components.
• Do not connect the unit to a dimmable power supply.
Switching on: Insert the power plug of the transformer into the socket.
• Check the function of the spotlights.
Switching off: Disconnect the transformer power plug.
Operation
The spotlight is operated using the buttons on the remote control:

Remedy of faults

Malfunction
Spotlights do not light up
Illuminating power decreasing
Spotlights can be switched on/off, but light
effects cannot be changed
12
Buttons Function
1 Switch on/off the spotlight.
2 Selection of effects. After selecting an effect, buttons 4 can be used to adjust the effect
speed.
3 Select the spotlight colour. After selecting a colour, buttons 4 can be used to adjust the
brightness.
4 Setting the effect brightness or speed.
Cause
Power supply interrupted
Transformer defective
Spotlight soiled
Remote control battery too weak
Remedy
Check power supply
Replace transformer
Clean
Replace the battery.