Installation And Connection - Pontec PondoStar LED Set 1 Instrucciones De Uso

Safe operation
 Never operate the unit if either the electrical cables or the housing are defective!
 Do not carry or pull the unit by its electrical cable.
 Route cables/hoses such that they are protected from damage and do not present a tripping hazard.
 Only open the unit housing or its attendant components, when this is explicitly required in the operating instructions.
 Only carry out work on the unit that is described in this manual. If problems cannot be overcome, please contact an
authorised customer service point or, when in doubt, the manufacturer.
 Only use original spare parts and accessories for the unit.
 Never carry out technical modifications to the unit.
 Power connection cables cannot be replaced. If a cable is damaged, dispose of the respective unit or components.
 Only operate the unit with the supplied transformer.
 Keep the socket and power plug dry.
 The power pack and the plug connectors of the power cables supplied are not water-tight, but only rain and splash-
proof. Do not route or fit in the water.

Installation and connection

 B, C
 The unit can be placed submerged or dry.
 For installation above water: Ensure a safety distance of at least 50 cm from combustible material.
Do not cover the unit!
 Install the transformer at a minimum safety distance of 2 m from the water.
How to proceed:
1. Position the unit such that it does not present a hazard to anyone and the lamps are tilted as desired.
2. Connect the plug of the spotlight connection cable to the socket on the transformer and hand-tighten the union nut.
Commissioning/start-up
Sensitive electrical components.
Possible consequences: The device will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
 Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:
Isolate the units and installations (switch off and disconnect from the power supply) before reaching into
the water.
 Isolate the unit before starting any work.
 Secure the unit to prevent unintentional switching on.
Switching on: Insert the power plug of the transformer into the socket.
 Check the function of the spotlights.
Switching off: Disconnect the transformer power plug.
- EN -
Fire hazard:
9