Safety Devices; Use According To Intended Purpose; Residual Risks - Mafell DD40G Manual De Instrucciones

1 pack of MAFELL special dowels ø 8x30 mm (5/16 x
1 3/16 in.)
(approx. 200 pcs.)
1 pack of MAFELL special dowels ø 10x40 (3/8 mm x
1 9/16 in.)
(approx. 100 pcs.)
Further scope of delivery:
1 bottle of glue
1 dowel nozzle ø 8 mm (5/16 in.)
2 anti-slip mats
1 Allen key with handle
1 service tool in bracket on the machine
1 carrying case
1 operating manual
1 folder "Safety Instructions"
DD40P PowerMAX
Item No. 916010, 916040, 916041, 916042, 916043,
916045
2 carbide-tipped dowel drill bits ø 8 mm (5/16 in.)
2 carbide-tipped dowel drill bits ø 10 mm (25/64 in.)
2 carbide-tipped dowel drill bits ø 12 mm (15/32 in.)
1 pack of MAFELL special dowels ø 8x30 mm (5/16 x
1 3/16 in.)
1 pack of MAFELL special dowels ø 10x40 mm (3/8 x
1 9/16 in.)
1 pack of MAFELL special dowels ø 12x60 mm (1/2 x
2 3/8 in.)
Further scope of delivery as MaxiMAX

2.7 Safety devices

Danger
These devices are required for the
machine's safe operation and may
not be removed or rendered
inoperative.
The machine is equipped with the following safety
devices:
- Protection against contact with the bits
- Large bearing faces of limit stops
- Handles and handle supports
- Hose connector

2.8 Use according to intended purpose

The DuoDübler is exclusively intended for drilling of
solid wood and panel materials such as chip board,
coreboard and Mdf-boards, using the drill bits
permitted, with diameters between 3 mm and 12 mm
(1/8 and 15/32 in.) (DD40G) and from 6 mm to 16 mm
(15/64 and 5/8 in.) (DD40P).
Any other use than described above is not
permissible. The manufacturer cannot be held liable
for any damage arising from such other use.
In order to use the machine as intended, comply with
the operating, maintenance, and repair instructions
specified by Mafell.

2.9 Residual risks

Danger
Even if used in accordance with its
intended purpose and despite
conforming with the safety
instructions, residual risks caused
by the intended use will always
remain.
- Touching the drill bits when fitted in or when
outside the base plate.
- Touching the drill bits on the workpiece rear when
drilling.
- Breakage of the drills and risk of the drill bits or
parts of them being hurled away.
- Touching live parts with the housing open and the
mains plug not removed.
- Hearing can be impaired when working for long
periods without ear protectors.
- Emission of harmful wood dusts during longer
operation without extraction.
-16-