Warming Zone Surface Element - GE PP945 Manual Del Propietário

Using the surface elements.
8

Warming Zone Surface Element

To turn on the warming zone surface
element:
Touch the warming zone ON/OFF
pad, then touch the (+)/(-) pad.
Use the (+)/(-) pad to choose a
setting of H (High) or L (Low).
To turn off the warming zone surface
element, touch the ON/OFF pad.
Food Type Control Setting
Breads/Pastries
Sauces
Soups (cream)
Stews
Vegetables
Hot Beverages
Soups (liquid)
The chart above shows initial suggested settings
only. The temperature, type and amount of food,
and the time held will affect the quality of the
food.
CAUTION: Do not warm food on the
WARMING ZONE for more than two hours.
Do not use plastic wrap to cover food. Plastic
may melt onto the surface and be very difficult
to remove.
Error During Operation
If an error occurs in the control
operation, the cooktop operation will
discontinue and the unit will shut
down completely.
To correct:
Attempt to set the control to the
desired cooking setting.
Allow the cooktop to cool
completely.
After the cooktop cools, attempt to
set the control to the desired
cooking setting.
(on some models)
Use only cookware recommended for top-of-range
cooking.
The WARMING ZONE will keep hot,
cooked food at serving temperature.
Always start with hot food. Do not use to
heat cold food. Placing uncooked or cold
food on the warming zone could result in
foodborne illness.
For best results, all food on the
WARMING ZONE should be covered with
L (LOW) a lid or aluminum foil. When warming
pastries or breads, the cover should be
L (LOW)
vented to allow moisture to escape.
L (LOW)
L (LOW)
Always use potholders or oven mitts when
L (LOW)
removing food from the WARMING ZONE
H (HIGH)
as cookware and plates will be hot.
H (HIGH)
A hot surface indicator light will glow
when the glass surface is hot and will
remain on until the surface has cooled
below 150°F.
If the cooktop will not operate, turn
off the cooktop power at the circuit
breaker or fuse box for one minute.
After one minute, turn on the
cooktop power at the breaker and
again attempt to set the control to
the desired cooking setting.
If the cooktop fails to operate, call
for service.