Safety Instructions - Bosch GTA10W Instrucciones De Funcionamiento Y Seguridad

BM 2610019165 10-11:BM 2610019165 10-11.qxp 10/13/11 7:50 AM Page 2
Read and understand all
WARNING
instructions. Failure to follow
all instructions listed below and in your tile saw
manual may result in serious personal injury.
Fully assemble and tighten all the fasteners
required for this stand. Also remember to
occasionally check the stand and make
sure it is still tight. A loose stand is unstable
and may shift in use and cause serious injury.
Turn tool switch off, disconnect tool power
and empty water from tray before mounting
on stand and removing from stand or
transporting. Unintended startup during
assembly can cause injury.
For your own safety, never connect plug to
power source outlet until all assembly steps
are complete and until you have read and
understood the entire owner's manual.
Model GTA10W Wet Tile Saw Stand is
shipped complete in one box and is specifically
designed for the Bosch TC10 Wet Tile and
Stone Saw.

Safety Instructions

Unpacking and Check Contents
Before operating make sure the entire unit
is placed on a solid, flat, level surface.
Serious injury could occur if tool is unstable
and tips.
Never stand on tool or its stand or use as
ladder or scaffolding. Serious injury could
occur if the tool is tipped or the cutting tool is
accidentally contacted. Do not store materials
on or near the tool such that it is necessary to
stand on the tool or its stand to reach them.
Use only Bosch replacement parts. Any
others may create a hazard.
If any parts are missing, do
WARNING
not attempt to assemble the
saw to the stand until the missing parts are
obtained and installed correctly.
TABle oF looSe PARTS
Item Description
A GTA10W Stand
A
-2-
Qty.
1