Charge" Card For Battery Powering; Maintenance; Technical Data - Nice ROBO RO 300 Manual De Instrucciones

English
7.1) "CHARGE" CARD also battery powered
The unit is equipped with a power transformer that can provide the motor's power requirement and that of the electronic card so
it can all be powered directly by the mains.
If you want the system to continue working in the case of a power cut then you have to add a suitable battery and the relative
battery charger card.
Due to the size of the battery it must be installed externally to the motor unit and connected to two terminals on the battery
charger card; the latter must be connected to the connector on the unit.

8) MAINTENANCE:

The card, being electronic, needs no particular maintenance. However check periodically, at least twice a year, the perfect
efficiency and adjustment of the device that controls maximum motor force and, if required, adjust with the trimmer.
Check effectiveness of the safety devices (photoelectric cells, pneumatic edges, etc.) and correct functioning of the flashing light.
TECHNICAL FEATURES OF THE UNIT:
Mains power
Battery power
Max. Access: current 24 Vdc
Max. flashing light power
Max gate-open power indicator
Pause time
Encoder resolution
Working temperature
30
: 230 Vac ±10% , 50 - 60 Hz
: 21 ÷ 28 Vdc (> 6Ah capacity)
: 200 mA
: 25 W ( 24 Vdc)
: 2 W ( 24 Vdc)
: from 1 to 1023 seconds
: 4.73 degrees (76 pulses/rev)
: -20 ÷ 70 °C