Foreseeable Misuse; Getting Started - Gloria CleanMaster EXTREME 100 Instrucciones De Uso

In practice, sprayed liquids are a mixture of
l
various substances whose composition is
GB
only known to the manufacturer. The suit-
ability of the unit for a specific liquid must
therefore be determined before use by the
user in conjunction with the manufacturer
of the substance.
The use of alkalis and acids is permitted only
after consultation with the equipment man-
ufacturer. Furthermore, thin oils can be
sprayed.

Foreseeable misuse

The device is not suitable for:
l
- acids and alkalis in any concentration.
- wetting agents (surfactants) that cause
or could promote the formation of cracks
in the plastics used.
- liquids at temperatures over + 40°C.
- inflammable liquids with a flash point
below + 55°C.
- very tenacious or sticky liquids, or liquids
that leave residues, which cannot be
completely poured or flushed out of the
unit.
On request, the manufacturer of the unit
l
can make available a detailed list of the
materials used in the parts of the unit for
more detailed examination.
Unauthorised changes to the unit made by
l
the user or inappropriate use shall render
null and void the liability of the manufac-
turer for any damage caused as a result.

Getting Started

WARNING!
Danger to health due to escaping
liquids!
A leaking device or device components can
lead to the liquid escaping or spraying out. For
this reason, observe the following safety
instructions:
- Check that the unit is in perfect condition
and properly sealed each time before use.
The safety valve must trigger at 3 bar
(approx. 20 pump strokes with 1l fill
volume).
- Only operate or move device when standing
upright.
- Inspect all screw joints for tight fitting.
Unscrew the valve body (B) by rotating to
l
the left out of the container for filling.
Fill the tank, see "Max. filling volume" in
l
the Technical data section and the tank
scale for details on the maximum amount
that can be put in.
WARNING!
Danger to health through contact with
the liquid!
Observe the max. filling amount (see Technical
Data) and the correct dosing given by the
spray producer.
Screw valve body (B) back in and pump up
l
the device. Peak pressure is reached when
the safety valve is triggered. Any excess
pressure will escape through the safety
valve.
12