Automated Fold Setup - Martin Yale 2601 Instrucciones De Uso

GB

4.2 Automated Fold Setup

Selecting paper size
Press the Paper key to select the desired paper size. Each press of the
key will step through the three standard paper sizes and "other" and will
light the appropriate paper size indicator on the control panel.
At the same time the display will show the selected paper size in
millimeters, for example:
T0
CHG:
If your paper isn't a standard size, press
size. Each key press will change the paper size by 0.5mm (roughly
1/64"). Holding the key down for more than one second will increase the
step size, allowing large changes to be made rapidly.
When the correct paper size is shown, proceed with "Selecting fold type"
below.
Selecting fold type
Before selecting a fold, make sure you have already set the machine to
the correct paper size. This will prevent the machine from setting up a
fold for the wrong paper size, which could result in a paper jam.
Press the Fold Type key to select one of the six pre-programmed fold
types. Each key press will turn on the indicator associated with each fold
type.
When you have made your selection, press the Enter key. The display
will show:
TEMP JOB: 0
SETTING
While the machine is setting up the fold, all keys on the control panel are
disabled and will not respond if pressed.
When the setup is complete, the display will change back to the "Ready"
state.
TEMP JOB: 0
Note: "TEMP JOB" or "T" in the display means that the job just setup
is considered a temporary job because it has not yet been saved in
memory.
PAPER = 297.0
DONE: Enter
or key to change the
READY
123456
Setting the speed
Set the proper speed before attempting to run the folder. The speed
setting depends on the weight and size of the paper used.
Light weight and large size papers (lighter than 80g/m
A4) must be run slower than heavy paper and smaller sheets. A good
value to start with is 35.
Press the Speed key. The display will typically show (for exampel 40):
0
CHG:
To change the speed, press the
If you forgot to press Enter and try to start the folder, the display will
show:
USE NEW SETTING?
YES: Enter
This message will also appear if you have entered any other new
parameter such as paper size, fold type, batch or fold plate setting.
Press Enter now to activate your setting or
setting.
The speed can also be changed while the machine is running.
Press the Speed key. The display will change to:
SPEED =
Use the or keys to run slower or faster. The speed will change
instantly. You need not press the Enter key to activate the new setting.
Trial piece
Always run a trial piece before starting a run. It is also a good idea to run
a trial piece each tine a new stack of paper has been loaded onto the feed
table. This will prevent a jam if the stack has been loaded incorrectly.
Press the Trial Piece key. A single sheet will be folded and delivered to
the stacker for you to check.
Start up
If you are happy with the trial piece, press the Start key to commence
automatic feeding and folding. The folded sheets will be delivered neatly
shingled on the stacker table. Remove the folded sheets as soon as they
start piling up in front of the stacker extension.
When the entire paper stack has been fed the machine will stop and the
display will show:
Reload the feed table with a new stack of paper and press the Enter key
to clear the message on the display.
When the display shows 'Ready', press the Start key to resume folding.
TEMP JOB: 0
25
MARTIN YALE
and larger than
2
SPEED = 40
DONE: Enter
or key, then press Enter.
NO:
to stay with your previous
35
123456
- FAIL TO FEED -
DONE – Enter
READY
123456
2601