Job Setup; Counters - Martin Yale 2601 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GB

4.3 Job Setup

Normal Job
The Normal Job is a commonly used setup which can be recalled very
quickly when required.
From the factory, this job is set to give a letter (C) fold on A4 size paper.
However, it can be set to a different fold and paper combination, if
required, by your service engineer.
To select the Normal Job, simply press the Normal Job key.
The display will ask:
SET NORMAL JOB?
YES: Enter
Press Enter to activate the Normal Job settings or press
changed your mind.
When the Normal Job is set, the display will show:
Mehr wird in diesem Modus nicht angezeigt.
Temporary Job
A Temporary Job is any folding job setup without it having been stored in
the machine's memory. The settings are not retained by the machine and
cannot be recalled at a future date.
A Temporary Job will be shown in the display by the word "TEMP" or the
letter "T":
TEMP JOB: 0
T1
CHG:
If you recall a programmed job and change any of its settings, it will be
regarded as a Temporary Job by the machine until it is saved again to
memory.
For details of saving a job in memory or updating a job already in memory
see under the headings of 4.5 "Memory Functions"
NO:
if you have
READY
123456
READY
123456
PAPER = 297.0
DONE: Enter

4.4 Counters

Clearing total count
The total count feature is always active and cannot be turned off. The
counter must therefore be reset for each individual job that requires
counting.
To reset the count, press the Reset Counter key. The display shows:
TEMP JOB: 0
Press the Enter key to reset the counter, or the
changed your mind. The counter digits at the bottom right of the display
will revert to zero:
TEMP JOB: 0
Setting a batch count
The batch count feature will make the machine fold a pre-selected number
of sheets (a batch) and then stop. The remaining folded sheets on the
stacker will be carried to the end of the stacker table to aid removal.
Folding of the next batch is resumed by pressing the Start key.
To set the batch function, press the Batch key. The indicator next to the
key will light and the display will show:
T0
CHG:
To change the batch count to any number between 005 and 999, use the
or
keys, then press Enter to confirm.
The indicator will remain lit and the display will change to:
TEMP JOB: 0
BATCH: 050
Turning off the batch counter
The batch count function will operate as long as the batch indicator is on,
even if the paper size and/or fold type is changed. To turn batching off,
press the Batch key.
The indicator will go off and the display will briefly show:
BATCH MODE OFF
Then go back to the normal running mode display:
TEMP JOB: 0
BATCH: 050
Restoring a batch count
If you have set a batch of 50, for instance, and have taken a trial piece
of have run several pieces you cannot use, you may want to restore the
batch count to 50 before starting a folding run. To do this, press the Batch
key (to turn batch off), then press the Batch key a second time (batch
setting mode on), then press Enter. The batch count will be restored and
the machine is ready to run a full batch.
28
MARTIN YALE
2601
READY
123456
key if you have
READY
000000
BATCH = 050
DONE: Enter
READY
123456
READY
123456

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

395

Tabla de contenido