Nemaxx EB52 Instrucciones De Uso página 23

KEN002EB52
POSSIBLE FAULTS
Fault code Possible cause
Machine does - Machine overloaded.
not work with - Air filter contaminated
full performance - Carburretor incorrectly
adjusted
- Silencer blocked
Drill rotates at - Idle speed too high
idling - Clutch spring broken
Drill rotates but - Choke put to OFF
has no power - Carburetor defective
- Gear broken
- Worn clutch shoes
Drill jumps - Drill damaged
Drill cuts only - Blunt drill
slowly
In the case of other faults please contact the customer service.
EN
Corrective action
- Soil too tough
- Clean or replace the air filter
- Contact the customer service
- Clean the outlet of the silencer
- Adjust a lower idle speed
- Replace the spring
- Put choke to ON once the engine runs
- Contact the customer service
- Contact the customer service
- Replace the clutch shoes and the spring
- Replace by a new drill
- Replace the drill or have it sharpened
23
v04 • 22.05.2017