Setting Alarm Time; Mounting Instructions - HoMedics DWS-150 Manual De Instrucciones E Información De Garantía

DWS-150-IB SP\ENG 10/12/04 11:30 AM

SETTING ALARM TIME

1. Hold the "CLEAR " button for 3 seconds. Press " + , - " on the back of the unit to
enter the desired Hr/ Min values. Press "CLEAR " to confirm.
2. To view alarm time - Press "CLEAR " button. Alarm time will display for 5 seconds
and then resume to normal clock thereafter.
3. To select between daily alarm and snooze alarm or alarm off - Press " + " button
on the back of the unit.
For Daily Alarm - The " " icon will appear in the upper left corner of the time display.
Z
Z
For Snooze Alarm - The " " icon will appear in the upper left corner of the time
display (see photo to the right).
Z
Z
No Alarm - The " " icons will not be shown.
4. The home receiver will provide either a daily alarm, which last for 2 minutes or a
snooze mode where the alarm will repeat every 8 minutes until manually cleared
(see SNOOZE/LIGHT section below.)
SNOOZE/ LIGHT
1. Press the SNOOZE/ LIGHT button for an extended backlight.
2. In snooze alarm mode, press this button to trigger a repetitive snooze alarm.
3. When daily alarm mode is selected, press " +/
to turn off the alarm for one day.
MIN/ MAX MEMORY SETTINGS
1. Press "MIN/ MAX" button to view the maximum values for 5 seconds. Press again
to view the minimum values.
2. To clear the memory record, press "CLEAR " while the respective values are
displayed on screen.
TEMPERATURE TREND INDICATOR:
In the upper right hand corner of the home receiver LCD display, you will see one
of 3 icons;
will indicate Rising Temperature readings if it changes more than
1 degree in an hour
will indicate Steady Temperature readings
will indicate Falling Temperatures if it is more than
1 degree in an hour.
Page 5
" button on back of home receiver
4
TEMPERATURE/ HUMIDITY ALERT
Press "ALERT" to turn temperature & humidity alert on
and off.
1. Hold "ALERT" button located on back of home receiver
for 3 seconds to enter the alert setting mode. The indoor
icon will flash.
2. Press " +, - " to select the between indoor temperature,
indoor humidity or remote sensor channel 1 to be alerted
to. Press "ALERT" to confirm your selection. The Upper
pointer and the value on the LCD display will flash, enter
the desired upper limit with the " +, - " buttons, press
"ALERT" to confirm your selection and then go to the
lower limit setting.
3. The Lower pointer and value will flash, enter the desired
lower limit with " +, - " buttons, press "ALERT" to confirm
and exit.
4. You may enter an alert setting for the indoor temp, indoor
humidity and temperature of the remote sensor channel 1.
5. When temperature hits the limit of your preset levels, the
Upper/Lower pointers and the temperature of the
respective channel (indoor or remote sensor channel 1)
will flash and produce an audible alarm. Press any button
on the home receiver to acknowledge and stop the alarm.
LOW BATTERY INDICATION
Low battery indication is available for the home receiver
and the remote sensor. "LO" will be displayed on the
remote sensor. A battery life " " icon will be shown
on the home receiver or on the remote sensor. Replace the
batteries as necessary and follow the setup procedure as
mentioned earlier in this instruction manual.

MOUNTING INSTRUCTIONS

Both the home receiver and remote sensor come with a table
stand or they can be wall mounted.
5