Setting Alarm Time - HoMedics DWS-400 Manual De Instrucciones Y Garantía

To select between mb/hPa and inHg, hold " P/A- " key for 3 seconds.
To view air pressure for the past 12 hours, press the "HIST" button to scroll
through the hourly readings. The respective values can only be available
after the barometer has recorded the pressure data in the past 12 hours.
Push any other button to cancel the "view history" selection.
The spectrum bar chart indicates the pressure changes (range from -8 to
+8 hPa mb) hourly over the past 12 hours.
SETTING THE CLOCK & CALENDAR
Hold "SET" button for 3 seconds to enter clock set.
1. Select 12 Hour or 24 Hour Setting - Using the " + , - " buttons located
on the back of the home receiver. Press "SET" button to confirm your
selection.
2. Select Fahrenheit/Centigrade - Use the " + , - " buttons located on the
back of the home receiver to adjust setting. Press "SET" button to
confirm your selection.
3. Select Year - Use the " + , - " buttons located on the back of the home
receiver to adjust year setting. Press "SET" button to confirm your
selection.
4. Select Month - Use the " + , - " buttons located on the back of the
home receiver to adjust month setting. Press "SET" button to confirm
your selection.
5. Select Day - Use the " + , - " buttons located on the back of the home
receiver to adjust day setting. Press "SET" button to confirm your
selection.
6. Select Language - Use the " + , - " buttons located on the back of the
home receiver to adjust language setting. Press "SET" button to confirm
your selection.
LANGUAGE
GE = German
EN = English
FR = French
IT = Italian
7. Select Hour - Use the " + , - " buttons located on the back of the home
receiver to adjust hour setting. Press "SET" button to confirm your
selection.
4
8. Select Minute - Use the " + , - " buttons located on the back of the
home receiver to adjust minute setting. Press "SET" button to confirm
your selection.
9. Select World Time Offset - Use the " + , - " buttons located on the back
of the home receiver to adjust "World Time Offset". Press "SET" button
to confirm your selection.

SETTING ALARM TIME

This unit features two alarms (Alarm 1 and Alarm 2).
"CLEAR/AL" button to scroll through alarm settings, press "+,
selection will be shown on the display.
1. Hold the "CLEAR/AL" button for 3 seconds. Press " + , - " to enter the
desired Hr/ Min values and press "CLEAR/AL" to confirm setting.
2. To view alarm time - Press "CLEAR/AL" button. Alarm time will display
for 5 seconds and then resume to normal clock thereafter.
3. The home receiver will provide either a daily alarm, which lasts for 1
minute or a snooze mode where the alarm will repeat every 10 minutes
until manually cleared (see SNOOZE/LIGHT section below).
4. To turn alarm(s) off for extended periods, press "+,
Alarm 1 and Alarm 2.
SNOOZE/ LIGHT
1. Press the "SNOOZE/ LIGHT" button (Zz/ light icon button) for an
extended backlight.
2. In snooze alarm mode, press this button to trigger a repetitive snooze
alarm.
3. When normal alarm mode is selected, press any button on the back of
the unit to turn off alarm for one day.
MAX/ MIN MEMORY SETTINGS
1. Press "MAX/ MIN" button to view the maximum values (In/Outdoor
Temp., Humidity, Pressure) for 5 seconds. Press again to view the
minimum values.
2. To clear the memory record, press "CLEAR/AL" button while the
respective values are displayed on screen.
5
To select one press the
". Your
To enter alarm time:
" to deselect both