➢
Handle installation instruction
▪
Open the door and carefully pull out the door gasket only at the area where the handle is to
be installed.
▪
You will be able to see two screws inside the door.
▪
Align the handle with the screws and tighten using a head screwdriver until the handle is
flush against the door frame.
CAUTION: Do not over-tighten the screws as this may cause damage to the handle or to the
stainless-steel door. Carefully press the door gasket into its original position.
➢ Reversing the door swing of your appliance
This appliance has the capability of the door opening from either the left or right side. The unit is
delivered to you with the door opening from the left side. Should you desire to reverse the opening
direction, please follow these instructions.
.
Note: All parts removed must be saved to do the reinstatement of door.
1. Open the glass door and remove the two screws under the right bottom corner of the glass door
that are used to hold the lower hinge to the glass door. Be careful to hold the glass door with hands
from dropping after
24