La Sommeliere CVDE46-2 Manual De Instrucciones página 27

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 65
Setting the temperature control
The Wine Cooler has two temperature zones.
✓ Upper zone – temperature range 5°C to 10°C
✓ Lower zone – temperature range 10°C to 20°C
You can set the required temperature either zone by pushing the Set upper or Set lower button.
When you push the two buttons for the first time, the LED readout will show the previously set
temperature set for that zones.
The temperature preset at the factory are: Upper zone: 6°C, Lower zone: 12°C
To set the temperature in the Upper zone press Set upper button once. The present temperature will
flash. The temperature will decrease by every time the button is pressed until minimum temperature
is reached, at which point it will then revert back to its maximum setting and start again.
To set the temperature in the Lower zone press the Set lower button and follow the instructions
above.
To view the temperature set in either zone at any time, press the corresponding "Set upper" or "Set
lower" button, the "Set" temperature will temporarily flash in the LED display for 5 seconds.
Panel control of CVDE21 – simple zone
Indicator light illuminates to signify the cooling mode is currently in operation.
To control this appliance, turn ON/OFF (press and hold this button for approximately
2 seconds).
To control the inner light, turn on/off.
Used to set temperature.
Setting the temperature control
You can adjust temperatures from 5 to 20°C.
This is the same use instructions as CVDE46-2
NOTE:
▪ If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the Wine Cooler will not start.
▪ When you use the Wine Cooler for the first time or restart the Wine Cooler after having been shut
off for a long time, there could be a few degrees' variance between the temperature you select
and the one indicated on the LED readout. This is normal and it is due to the length of the
activation time. Once the Wine Cooler is running for a few hours everything will be back to
normal.
27

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cvde21

Tabla de contenido