Assembly; Commissioning - Gloria FoamMaster FM 30 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 49
RZ_FM 30_1018.qxp_Text_GB 25.10.18 09:55 Seite 20
5

Assembly

5.1
Figures
6

Commissioning

DANGER
WARNING
components may result in draining or spouting of cleaning fluid. For this reason, observe the
following safety instructions:
 Prior to each use, check the device to ensure fault-free condition and leak-tightness.
To perform the leak test, fill the container with water! Pull up the safety / pressure relief
valve (K) by hand and check that it returns to the starting position.
 Only operate or move device when standing upright. Do not tilt to one side or hold upside down.
 Inspect all screw joints for tight fitting.
6.1 Fill the tank
6.1.1 Check the safety valve
6.1.2 Vent the tank, drain the water & fill with foaming agent
Figures
NOTE
 Pull the safety / vent valve on the piston gauge with integrated safety valve (K) until the
device is depressurised.
 Prior to filling the foaming device, observe the instructions relating to particular hazards
(R-phrases / German Hazardous Substances Ordinance [GefStoffV]) and safety advice (S-
phrases / German Hazardous Substance Ordinance [GefStoffV]) provided on the chemical
containers according to the regulations.
 Observe the max. fill level (see technical data). The regulations of the foaming agent
manufacturer specify the correct dosage and concentration.
6.2 Changing foam cartridges and spraying results >>
 Work with the blue foam cartridge (G2) when using the GLORIA Green Growth Remover, the
GLORIA Basic Stone Cleaner and the GLORIA Wood / WPC Cleaner.
6.3 Applying pressure and spraying >>
CAUTION
device and the foaming agents. You must therefore always comply with the safety instruc-
tions / safety measures in this user manual, as well as the following instructions:
 The device must only be operated when suspended in a vertical or steep upright position.
 Pressing the actuation lever down on the quick closure valve initiates the spraying process.
This can be interrupted immediately by releasing the actuation lever.
1
3
Before putting into operation, observe Chapter 2 "For your safety".
Health risk through leaking cleaning fluid! A leaking device or leaking
>>
Figures
7
9
>>
Figure
7
You may be exposed to hazards that could injure you when handling the
4
6
Figure
Figures
11
14
20
10

Publicidad

Tabla de contenido
loading

Tabla de contenido