Lenco L-400BK Manual Del Usuario página 5

SET-UP
Some assembly required before you can begin to use your new unit. Please follow the assembly instruction
below before attempting to use you new turntable.
ASSEMBLY:
Before you begin assembly please be sure all parts and accessories have arrived intact.
NOTES:
Do not connect the AC power plug before assembly has been completed.
Before turning the power on, make sure once again all the connections and power voltage settings are
correct. Always turn off the power when connecting or disconnecting.
Read this manual carefully before using the unit. Be sure to store the manual in a safe place for future
reference.
Attach a stylus cartridge to the HEADSHELL before assembling the turntable unit.
Headshell Assembly:
When installing a cartridge, refer to the operating instructions of that cartridge. During installation, attach the
stylus protector to guard the stylus tip from damage.
Connect the HEADSHELL lead wires to the cartridge terminals. The terminals of cartridges and the
HEADSHELL lead wires are color coded. Connect each lead wire to the cartridge terminals of the same color.
White (L+) .............................. Left channel +
Blue (L-) ................................. Left channel –
Red (R+) ................................ Right channel +
Green (R-) ............................. Right channel –
Turntable Assembly:
1. REMOVING FROM CARTON:
Carefully remove the main unit with the packing material intact from the box. Remove the packing material
once the unit has been removed from the shipping carton. Be sure to locate all the accessories located in
the packing material.
2. 45 ADAPTER:
Locate and remove the 45-rpm adapter from the packing material and place it in the 45 adapter cutout on
the top of the main unit.
3. TURNTABLE PLATTER:
Remove the turntable platter from the packing material and gently insert the platter into the CENTER
SPINDLE on the base of the turntable unit.
4. SLIPMAT:
Remove the black slipmat from the packaging and place it on the PLATTER.
5. HEADSHELL:
Insert the HEADSHELL into the front end of the TONEARM ASSEMBLY. While holding HEADSHELL firmly
into the front end of the tonearm assembly, turn the HEADSHELL LOCKING NUT counter- clockwise to
firmly secure the HEADSHELL to TONEARM ASSEMBLY.
HEADSHELL
TONEARM ASSEMBLY
HEADSHELL LOCKING NUT
5