Cleaning And Storage; What If There Are Problems - Beurer FM 250 Vital Legs Instrucciones De Uso

7. Cleaning and storage

Cleaning
WARNING
• Always unplug the mains part from the socket and disconnect it from the device before
• carrying out any cleaning.
• Remove the batteries from the EMS circulation stimulator every time you clean.
• Only clean the appliance in the manner specified. Fluid must never be allowed to
enter into the device or accessories.
• Clean the foot electrode surface and the cuffs with a cloth or damp sponge after each
use. Do not use any solvent-based cleaning products.
• Leave the EMS circulation stimulator to dry at room temperature, away from heat
and sunlight.
• Do not use the EMS circulation stimulator again until it is completely dry.
Storage
If you do not plan to use the EMS circulation stimulator for a long period of time, we recom-
mend that you store it in the original packing in a dry environment, ensuring it is not weighed
down by additional items. Store the EMS circulation stimulator away from children, pets and
pests. Do not place any objects on the EMS circulation stimulator. Remove the batteries from
the EMS circulation stimulator and remote control. Make sure that the storage conditions
are met in the storage location.

8. What if there are problems?

Problem
The EMS circulation
stimulator will not
switch on.
The remote control is
not responding.
The EMS circulation
stimulator is switched
on but I cannot feel any
electrostimulation.
The electrostimulation
is too weak.
Cause
The batteries are flat.
The batteries are not
inserted correctly.
The EMS circula-
tion stimulator is not
plugged in.
The batteries are flat.
The batteries are not
inserted correctly.
Your feet are too dry.
The set intensity level
is too low.
33
Solution
Replace the batteries in the EMS
circulation stimulator.
Ensure that the batteries are inserted
correctly. Observe the plus (+) and
minus (−) polarity signs.
Connect the mains adapter to the
EMS circulation stimulator and a
suitable socket.
Replace the batteries in the remote
control.
Ensure that the batteries are inserted
correctly. Observe the plus (+) and
minus (−) polarity signs.
Moisten the bottom of your feet. If
necessary, increase the intensity
level.
Increase the intensity level.