Installing Chain Suspended Units - Hatco GLO-RAY Serie Manual De Instalación Y Operación

INSTALLATION

Installing Chain Suspended Units

Chain suspended mounting attaches the unit to an overhead
surface with the use of "S" hooks. "S" hook mounted units are
available in 120 V only and are required to have a power cord
and plug connection.
NOTE: Units ordered with the "S" hook option come with two
"S" hooks and two 152 mm (6") lengths of chain.
Additional chain (P/N 05.03.020.00) can be ordered
from Hatco for the overhead mounting system or
another option can be determined by a qualified
installer.
WARNING
For installation with chains, make sure the chains have
sufficient strength and are securely fastened to both the
unit and the mounting location. Poorly installed chains
may cause the unit to loosen and fall. Do not place
anything on top of units installed with chains.
Ensure safe and proper operation. Refer to the "Minimum
Clearance Requirements" listed in the Installation section
of this manual.
NOTE: The strength of the chain supplied by Hatco is sufficient
to hold the weight of the unit securely only when
mounted properly.
1. Prepare the overhead mounting system for the "S" hooks.
Make sure the system is secure and is set up so the unit
will be suspended at a level, safe, and proper distance
from walls, counter, and food.
2. Loosen, but do not remove the screws securing the hanger
tabs on each end of the unit. Rotate the tabs up, then
tighten the screws securely.
3. Securely attach one of the 152 mm (6") connecting chains
between each pair of hanger tabs.
4. attach an "S" hook to the center of each connecting chain.
5. Carefully lift the unit and attach the "S" hooks on each end
of the unit to the overhead mounting system. Make sure
the unit is level.
Overhead Mounting
System
Figure 17. "S" Hook Mounting
22
"S" Hook
Connecting Chain
Hanger Tab
Screw
Form No. GRCEM1-0611