Technical Data; Safety Notes - brennenstuhl SL DN 2806 S SKII IP54 Manual De Instrucciones

Operating Instructions
D
SMD LED tripod lamp
SL DN 2806 S SKII IP54
Please note: Please read these instructions carefully prior to mounting the light and store them
in a safe location afterwards!

TEcHNIcaL DaTa:

Type of protection:
Protection class:
Nominal voltage:
Operating temperature: -20°C – +40°C
Article:
Output:
Connection cable:
PrOPEr INTENDED uSE:
This high-performance LED lamp is for lighting interior and exterior areas (e.g. workshops,
camping, garage, household, etc.). The LED lamp is delivered, ready to connect, with a connection
line and round pin attachment plug. The lamp is spray water-resistant.
Any other use than those described above or modifications to the device are not permitted.
OPEraTION:
Mount the lamp on the tripod as shown in the Fig.
Place the tripod on a dry, flat surface.
Make sure the tripod is sufficiently stable
and the lamp is securely installed.
The lamp can be switched on and off
using the switch on the rear side.

SafETy NOTES:

1. Prior to commissioning, make sure the right voltage is available.
2. Prior to each use, make sure the light and mains supply cable are not damaged in any way.
Never use the lamp if you find damage.
caution! a damaged light or mains supply cable pose a risk to life due to electric shock!
3. Do not use this light without properly attached gaskets!
4
BA_Stativ_SMD_LED-Leuchte_16P048_1-17560-0_SL-DN-2806-S-SK-II.indd 4
IP 54
II
220 – 240 V~ 50/60 Hz
SL DN 2806 S SKII IP54
20 W
5 m H07RN-F 2x1.0
Fastening screw
Spring washer
Flat washer
07.07.16 15:45